Installing the starter motor

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Volvo S80, 2005 Volvo S80, 2004 Volvo S80, 2003 Volvo S80, and 2002 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Starter Motor Screw

Courtesy of VOLVO CARS OF NORTH AMERICA.

Remove the cranking tool

Install:

the starter motor. Tighten the screws. Tighten to 40 Nm
the positive cables and the connector
the nut for the positive cables. Tighten to 25 Nm
the screw for the bracket. Tighten to 25 Nm . Use a ratchet wrench.