Installing the screws in the transmission and engine

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Volvo S80, 2005 Volvo S80, 2004 Volvo S80, 2003 Volvo S80, and 2002 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Transmission, Starter Motor And Ground Lead Screws

Courtesy of VOLVO CARS OF NORTH AMERICA.

Install:

the 3 screws for the transmission and engine. Tighten to 50 Nm
the ignition setting sender and the screw. Tighten to 10 Nm
the screw for the clamp for the positive cable. Tighten to 10 Nm .