Removing the screws from the sub-frame support plates (both sides)
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Volvo S80, 2005 Volvo S80, 2004 Volvo S80, 2003 Volvo S80, and 2002 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.
Preparations for removal of the wheel knuckle
- Position transmission jack (applied lightly) under the right-hand side of the sub-frame. 9985972
- Slacken off both the sub-frame screws completely. Screw the screws back in approximately 5 turns.
- Release the sub-frame so that it rests on the screws and the mobile jack.