Removing the cap for the drive shaft support bearing

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Volvo S80, 2005 Volvo S80, 2004 Volvo S80, 2003 Volvo S80, and 2002 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Locating Drive Shaft In Gearbox

Courtesy of VOLVO CARS OF NORTH AMERICA.

Remove the screws for the bearing cap.

Unhook the servo pipe and the evaporator pipe from the holders on the right-hand side of the sub-frame. Unhook the servo pipe from the clip on the sub-frame.