Removing the line pressure solenoid
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Volvo S80, 2005 Volvo S80, 2004 Volvo S80, 2003 Volvo S80, and 2002 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.
Remove:
- the connector
- the spring clamp. Pull it straight out. Use a small screwdriver to bend the clamp out slightly
- the solenoid from the control system. Use a screwdriver. Insert it between the solenoid and the control system. Carefully pry and pull on the solenoid at the same time. Check that the O-rings remain on the solenoid.