Removing the oil pump
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Volvo S80, 2005 Volvo S80, 2004 Volvo S80, 2003 Volvo S80, and 2002 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
In order to replace the lock-up solenoid, the oil pump must be removed from the control system. This is so that the spring clip holding the solenoid can be accessed.
The shiny screw (1) must not be removed, it holds the oil pump together.
Remove:
- the temperature sensor with the cable harness from the clip
- the connector from the solenoid. Fold the cable harness out of the way
- the screws, not the shiny screws (1).
NOTE:
The dimension of the upper screws.