Removing the servo cylinder (2-1)
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Volvo S80, 2005 Volvo S80, 2004 Volvo S80, 2003 Volvo S80, and 2002 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.
Remove the three screws.
Pull down the cover with the servo cylinder. Check the position of the small strainer on the cylinder.
CAUTION:
Note the position of the strainer for reinstallation.
Lift the piston from the cover.