Installing the pressure sensor

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Volvo S80, 2005 Volvo S80, 2004 Volvo S80, 2003 Volvo S80, and 2002 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Pressure Sensor

Courtesy of VOLVO CARS OF NORTH AMERICA.

Apply a little automatic transmission fluid on the sensor O-rings.

Install:

the pressure sensor
the screws loosely (finger tight).

NOTE:

The upper screw is a M10 screw head. The three long screws are M8. The two shiny short screws are self tapping and should go into the same threads as before.

Tighten the screws lightly crosswise. The tighten to the black screws to 12 Nm .

Then tighten the two self tapping screws to 8 Nm .

Install:

the connector
the clip for the cable harness for the pressure sensor.