Preparations for removal of the gearbox side cover
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Volvo S80, 2005 Volvo S80, 2004 Volvo S80, 2003 Volvo S80, and 2002 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.
Blow clean thoroughly around the gearbox.
Collect the oil spill when the side cover has been removed.
Remove the nut for the clamp and the bracket holding the wiring.
Cut off the tie straps (2) holding cable harness above the bracket. Push the wiring to one side to access the screw.
Remove the screw and the bracket.
Remove all the screws from the side cover (the lower 5 screws are Torx screws).
CAUTION:
Ensure that the lower and outer screws align correctly during installation.