LEMON Manuals: Even more car manuals for everyone
Home >> Volvo >> 2002 >> S60 Base, 2.4 61, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 66 (Transmission - Removal, Replacement And Installation - 2 Of 2) >> Transmission, Automatic (B6284T, 4T65EV-Gt; 1999-2001) >> Control system/valve housing, removing >> Check the balls sealing against the distribution plate

Check the balls sealing against the distribution plate

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Volvo S80, 2005 Volvo S80, 2004 Volvo S80, 2003 Volvo S80, and 2002 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:

Check that the balls are round and smooth. Replace any defective balls.

Feel the holes for the balls. Check that there is not a rough lip around the hole.

Turn each ball in turn in their hole (to remove dirt or burring).

Place the ball in the hole. Press the ball and turn the ball in the hole to see that the ball seals and that the holes in the plate are not oval.

Check the sealing of the balls against the control system housing 

Carry out the same check as above for the 4 balls in the control system housing.

Remove the balls. Wipe off the petroleum jelly.

scientia non olet · About LEMON Manuals