Preparations for lowering the sub-frame
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Volvo S80, 2005 Volvo S80, 2004 Volvo S80, 2003 Volvo S80, and 2002 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.
Unhook the link arms from the ball joints on both sides. Use: 9997076 . Install: 9995562 . Hold the sleeve in place with the ball joint nut.
Bend out the spring struts and detach the drive shafts from the wheel hubs so that the gaiters are not damaged. Hold the spring struts away using a retaining strap to obtain better space when the drive shafts are removed.
Keep the seal on the outer constant velocity joint housing if it falls off.
Remove the screws from the sub-frame support plates (both sides).
Apply: 9985972 together with: 9995972 lightly under the right-hand side of the sub-frame.
Slacken off the screws for the sub-frame on the right hand side. Ensure that the nuts are still secured by at least 5 threads.
Remove 9985972 .