Installing the gear-shift position sensor, continued

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Volvo S80, 2005 Volvo S80, 2004 Volvo S80, 2003 Volvo S80, and 2002 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Gear Selector Cable

Courtesy of VOLVO CARS OF NORTH AMERICA.

Install:

the cable duct on the stud on the gear-shift position sensor. Tighten the nut. Tighten to 25 Nm
the lever on the gear shift linkage rod. Tighten to 16 Nm
the transmission cable on the lever on the bracket for the cable on the transmission. Tighten to 25 Nm .