Installing the control system

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Volvo S80, 2005 Volvo S80, 2004 Volvo S80, 2003 Volvo S80, and 2002 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Control System Screws

Courtesy of VOLVO CARS OF NORTH AMERICA.

NOTE:

Ensure the lever for the gear selector is set to neutral.

Align the control system on the lever for the gear selector.

Install:

the screws for the control system
a new gasket for the cover on the control system. Note that the screws are of different lengths (measured in mm).

Lightly tighten the screws alternately. Then tighten alternately. Tighten to 10 Nm .