Front Wheel Hub Steel: Installation

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Volvo S80, 2005 Volvo S80, 2004 Volvo S80, 2003 Volvo S80, and 2002 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.

Installing the hub

Fig 1: Hub Screws

Courtesy of VOLVO CARS OF NORTH AMERICA.

Install the hub. Use new screws
Press in the end of the drive shaft 10-20 mm
Use sleeve 3/8 mounting
Tighten the screws for the hub alternately. First tighten to 20 Nm . Then tighten to 65 Nm
Then angle-tighten to 60° .
See Screwed joint, torque/angle joint .

Installing the brake disc

Fig 2: Installing Brake Disc

Courtesy of VOLVO CARS OF NORTH AMERICA.

Install the brake disc.

Tighten the brake disc locating pin. Tighten to 8 Nm .

NOTE:

Ensure that the brake disc and wheel rim hub mating surfaces are clean.

Tighten the new drive shaft screw. See Summary of tightening torques for specific components .

Use bevel protractor 9512050 .

Installing brake calipers

Fig 3: Brake Caliper And Limiter Mounting Screws

Courtesy of VOLVO CARS OF NORTH AMERICA.

Install the brake caliper and the limiter
Use new screws
Tighten to 100 Nm
Install the wheel. See Installing wheels .