Front Wheel Hub Aluminium: Installation
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Volvo S80, 2005 Volvo S80, 2004 Volvo S80, 2003 Volvo S80, and 2002 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.
Installing the hub
- Install the hub. Use new screws
- Tighten crosswise to 20 Nm
- Then tighten to 65 Nm
- Angle-tighten 60° . Use bevel protractor 9512050 .
Turn in the spring strut and position the drive shaft in the hub.
NOTE:
Check that the seal is not worn or damaged.
Installing the drive shaft
- Install the screw loosely on the drive shaft. Use a new screw
- Align the ball joint in the control arm
-
NOTE:
Be very careful when releasing the tension strap.
- Release the control arm slowly using the tension strap.
Installing the ball joint
Install a new nut on the ball joint.
NOTE:
The ball joint must not rotate. Use a Torx spanner as a counterhold so that the rubber boot is not damaged.
Tighten, see: Tightening torque .
Installing the brake disc
Install the brake disc.
Tighten the brake disc locating pin. Tighten to 8 Nm .
NOTE:
Ensure that the brake disc and wheel rim hub mating surfaces are clean.
Tighten the new drive shaft screw. See Summary of tightening torques for specific components .
Use angle gauge 9512050 .
Installing brake calipers
- Install the brake caliper and the limiter
- Use new screws
- Tighten to 100 Nm .
- Install the wheel. See Installing wheels .