Removing The Engine Cooling Fan (FC)
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Volvo S80, 2005 Volvo S80, 2004 Volvo S80, 2003 Volvo S80, and 2002 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.
Remove
- the brake vacuum hose from the ejector valve
- The canister purge (CP) valve from the mounting on the fan shroud. Disconnect the connector.
Expose the wiring and the breather tube for the radiator.
Disconnect the connectors for the engine cooling fan (FC).
Remove
- the screws securing the fan shroud to the front panel
- the dip stick
- the upper oil hose for the transmission at the connection to the radiator (automatic transmissions only). Seal the openings.
Lift up and remove the engine cooling fan (FC).
Remove
- the connectors for the pressure sensor and temperature sensor in the plastic charge air pipe between the charge air cooler (CAC) and the throttle body (TB)
- the rubber hose at the intake for the charge air cooler (CAC)
- the brake vacuum hose at the intake manifold
- the plastic pipe between the throttle body (TB) and the charge air cooler (CAC)
- the lower oil hose for the transmission at the connection to the radiator (automatic transmissions only). Seal the openings.
Install radiator protection 9995474 .