Installing The Three-Way Catalytic Converter (TWC) (All-Wheel Drive (AWD) Only)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Volvo S80, 2005 Volvo S80, 2004 Volvo S80, 2003 Volvo S80, and 2002 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.

Lubricate the studs where the exhaust system separates downstream of the three-way catalytic converter (TWC). Use paste 116 1408.

WARNING:

Avoid skin contact with the paste.

Lift up the exhaust system and connect it to the rear system. Use a new gasket and new nuts.

HINT: Use a mobile jack with universal plate 9995972 as a support.

NOTE:

The routing of the heated oxygen sensor (HO2S) wiring over the brake pipe.

Install the screws holding the SIPS member to the bodywork. Tighten the screws.

Press the brake pipe into place in the holders on the SIPS member.