Installing The Engine Coolant Fan (FC)
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Volvo S80, 2005 Volvo S80, 2004 Volvo S80, 2003 Volvo S80, and 2002 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.
Install
- the lower engine coolant hose to the radiator. Tighten the clamp
- the lower oil cooler hose for the transmission to the radiator (automatic transmissions only). Use new O-rings
- the plastic charge air pipe between the throttle body (TB) and the charge air cooler (CAC). Only connect the plastic pipe at the throttle body (TB). Do not tighten the clamp.
Remove radiator protection 999 5474
Install
- the engine cooling fan (FC). Tighten the screws securing the fan shroud to the front panel
- the plastic charge air pipe to the connection at the charge air cooler (CAC). Tighten both the clamps. Connect the connectors for the temperature and pressure sensors in the plastic pipe
- the canister purge (CP) valve to the bracket at the fan shroud. Secure the EVAP hose to the clip at the lower section of the fan shroud
- the brake vacuum hoses
- the upper oil cooler hose for the transmission to the radiator (automatic transmissions only). Use new O-rings.
Press down the right side of the cooler unit. Pull the wiring for the pressure switch (Pressostat) into the drier bottle.
Connect the connectors to
- the engine cooling fan (FC) (x2)
- the canister purge (CP) valve.
Secure
- the breather tube for the radiator at the top of the fan shroud
- the wiring at the lower right corner and at the top of the fan shroud.
Install
- the rubber hose to the inlet side of the charge air cooler (CAC)
- the plastic charge air pipe above the engine. Tighten all clamps. Secure the pipe on the engine
- the upper coolant hose. Tighten the clamp
- the ventilation pipe between the control module box and fan shroud
- the air cleaner (ACL) assembly. Connect the plastic hose to the mass air flow (MAF) sensor. Tighten the clamp
- the air cleaner (ACL) intake pipe.
Connect the connector to the mass air flow (MAF) sensor. Secure the wiring at the front of the air cleaner (ACL) housing.
Install the support brace between the suspension turrets. Secure the servo hose to the right mounting on the support brace.