Lowering Sub-Frame

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Volvo S80, 2005 Volvo S80, 2004 Volvo S80, 2003 Volvo S80, and 2002 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Bolts, Washers And Brackets In Sub-Frame

Courtesy of VOLVO CARS OF NORTH AMERICA.

Slacken off the subframe screws. Lower the sub-frame slightly.

Remove the heated oxygen sensor (HO2S) bracket on the reverse of the sub-frame.

Unscrew the screws for the sub-frame approximately 2.5 cm on the right-hand side.

Fully remove the screws on the left-hand side.

Angle the sub-frame down on the left-hand side.

Ensure that the screws for the steering gear release from the frame.