Installing Components
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Volvo S80, 2005 Volvo S80, 2004 Volvo S80, 2003 Volvo S80, and 2002 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.
Install new nuts on the ball joints. Tighten to 80 Nm .
Counterhold using a Torx wrench so that the ball joint boot is not damaged.
Install the anti-roll bar links. Use new nuts. Tighten to 50 Nm .
Counterhold using a Torx wrench so that the boot is not damaged.
Install:
- the screw and nuts for the steering gear. Use new nuts and new screws. Tighten to 50 Nm
- the front engine pad. Tighten to 50 Nm
- the torque rod. Tighten the screws through the oil pan. Tighten to 50 Nm . Tighten the nuts in the sub-frame. Tighten to 65 Nm
- the center screw for the drive shaft. Use a new screw. Counterhold using a screwdriver in the brake disc vents. Tighten to 50 Nm
- the front air baffle
- the front wheel.