Installing Components On The Sub-Frame

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Volvo S80, 2005 Volvo S80, 2004 Volvo S80, 2003 Volvo S80, and 2002 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Oil Pipe And Clamps For Steering Gear

Courtesy of VOLVO CARS OF NORTH AMERICA.

Install:

the screw for the cable and air duct
the oil pipe for the steering gear in the snap fasteners along the sub-frame
the hose for the EVAP canister in the clip on the upperside of the sub-frame
the engine block heater and the fuel line to the engine block heater if applicable
the air duct in the clips
the screw for the ground cable bracket
the connectors for the heated oxygen sensors (HO2S) in the clips at the rear of the sub-frame.