Installing The Sub-Frame

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Volvo S80, 2005 Volvo S80, 2004 Volvo S80, 2003 Volvo S80, and 2002 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.

Position the sub-frame on a lifting table
Carefully lift the sub-frame
Locate the control arms on the ball joints and the steering gear on its mountings
Remove the hook (999 5045) that is holding the steering gear
Lift the sub-frame up completely.

Fig 1: Identifying Bolts, Washers And Brackets In Sub-Frame

Courtesy of VOLVO CARS OF NORTH AMERICA.

Install the four screws in the subframe together with the sub-frame brackets. Use new screws . Lubricate the screws
First tighten the screws on the left-hand side of the sub-frame. Tighten to 105 Nm . Angle-tighten 120° . Then tighten the right-hand side to the same values
Finally tighten the screws for the brackets on both sides to 50 Nm .