Installing Right Engine Pad
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Volvo S80, 2005 Volvo S80, 2004 Volvo S80, 2003 Volvo S80, and 2002 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.
Install
- the new engine pad.
- new screws for the mounting in the sub-frame (A) and engine (B). Do not tighten yet.
Carefully lower the engine and remove mobile jack.
Tighten the screws to the sub-frame to 65 Nm (47.9 lb. ft) and angle-tighten 60° . Use bevel protractor 9512050 .
Tighten the screws to the engine to 35 Nm (25.8 lb. ft) and angle-tighten 90° .
- the crankshaft vibration damper. Tighten to 35 Nm (25.8 lb. ft) . Angle-tighten 50° .
- both the plastic nuts holding the cover in the right fender liner.
- right front wheel according to Installing wheels .