Installing Cross Stay/Upper Torque Rod
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Volvo S80, 2005 Volvo S80, 2004 Volvo S80, 2003 Volvo S80, and 2002 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.
Install
- cross member.
- screws at suspension turrets. Tighten to 50 Nm (36.9 lb. ft) .
- torque rod mounting screw in the bracket on the engine.
Tighten the torque rod to 80 Nm (59.0 lb. ft) .
Tighten the screws between the cross stay and brackets at the suspension turrets to 80 Nm (59.0 lb. ft) .