Removing/Installing The Rear Camshaft Seal: Finishing

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Volvo S80, 2005 Volvo S80, 2004 Volvo S80, 2003 Volvo S80, and 2002 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Engine And Stabilizer Brace

Courtesy of VOLVO CARS OF NORTH AMERICA.

NOTE:

For tightening torques, see Tightening torque .

Install:

the trigger wheel. Tighten the screw
the camshaft position (CMP) sensor housing. Tighten the screws
the air cleaner (ACL) cover
the engine stabilizer brace. Tighten the screws
the screw holding the engine stabilizer brace to the bracket on the engine. Tighten.

Test drive the engine.