Replacing Auxiliaries Belt

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Volvo S80, 2005 Volvo S80, 2004 Volvo S80, 2003 Volvo S80, and 2002 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Vibration Damper Screws, Counterhold And Crankshaft Central Nut

Courtesy of VOLVO CARS OF NORTH AMERICA.

Raise the car and remove

the right front wheel
the plastic nuts from the cover in the fender liner
the vibration damper. Use the crankshaft center nut as a counterhold
the auxiliaries belt.

Install

new auxiliaries belt
the vibration damper. Tighten to 35 Nm . Angle-tighten 50° . Use the crankshaft center nut as a counterhold.
Use bevel protractor 9512050
the plastic nuts from the cover in the fender liner
the wheel. See Installing wheels .