Auxiliaries Belt / Belt Tensioner, Replacing: Preparation
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Volvo S80, 2005 Volvo S80, 2004 Volvo S80, 2003 Volvo S80, and 2002 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Trigger Wheel, Camshaft Position (CMP) Sensor Housing, Air Cleaner (ACL) Cover, Intake Manifold Between Electronic Throttle Module (ETM) & Engine Stabilizer Brace
Lift up the servo reservoir and place on top of the engine.
NOTE:
Ensure that no oil leaks out of the ventilation hole in the cover.
Use a 15 mm wrench and turn clockwise as far as possible to relieve the load.
Lift off the belt.