Installing The Cylinder Head
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Volvo S80, 2005 Volvo S80, 2004 Volvo S80, 2003 Volvo S80, and 2002 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.
Install a new cylinder head gasket.
Install the cylinder head. Use new screws.
Lubricate and install all the screws.
Tighten the screws in the order illustrated.
Tighten the screws in the following order.
- 20 Nm
- 60 Nm
- Angle tighten 130° . Use bevel protractor 9512050 .
If the cylinder head has been replaced or machined:
Install:
- coolant outlet pipe.
- new gasket with the two center screws in the lower row.
- the lower part of the intake manifold. See Installing the intake manifold, lower section .