Installing Components To Turbo 2

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Volvo S80, 2005 Volvo S80, 2004 Volvo S80, 2003 Volvo S80, and 2002 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Installing Torque Rod Bracket, Upper Screw Securing Automatic Transmission Dipstick Pipe To Engine & Ground Leads

Courtesy of VOLVO CARS OF NORTH AMERICA.

Lower the car.

Tighten the pipe screw of the oil pressure pipe to 18 Nm .

Install

the charge air pipe. Position and tighten the clamp.
the intake pipe. Position and tighten the clamp.
NOTE:
Remove the previously installed seals.
the torque rod bracket.
the upper screw securing the automatic transmission dipstick tube to the engine. Tighten the lower screw.
the heat deflector plate above the turbocharger.
the ground cable between the firewall and the torque rod bracket.
the clamp between the coolant pump intake pipe and the turbocharger oil pressure pipe.