Removing Intake Manifold

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Volvo S80, 2005 Volvo S80, 2004 Volvo S80, 2003 Volvo S80, and 2002 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Intake Manifold

Courtesy of VOLVO CARS OF NORTH AMERICA.

Remove:

The EVAP hose from the intake manifold
the by-pass valve vacuum hose. Disconnect the connector for the electronic throttle module (ETM)
the upper row of screws holding the intake manifold to the cylinder head. Slacken off the lower screws. Lift up the intake manifold. Remove the pipe screw for the water heated crankcase ventilation underneath the intake manifold
the pipe screw for the crankcase ventilation from the underside of the intake manifold.

Lift up and remove the intake manifold.

NOTE:

Make sure that the fuel pressure pipe is not damaged.