Setting Up The Engine

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Volvo S80, 2005 Volvo S80, 2004 Volvo S80, 2003 Volvo S80, and 2002 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Crankshaft Installed

Courtesy of VOLVO CARS OF NORTH AMERICA.

Position the crankshaft
Remove the starter motor mounting screws. Pull out the starter motor and place it to one side
Remove the blind cover plug
Turn the crankshaft slightly clockwise .
Install crankshaft stop 9995451 . Ensure that it bottoms out against the cylinder block.
Turn the crankshaft counter-clockwise until it stops against the crankshaft stop
Check that the marking on the crankshaft timing gear pulley corresponds with the marking on the oil pump.