Removing The Timing Gear Pulley
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Volvo S80, 2005 Volvo S80, 2004 Volvo S80, 2003 Volvo S80, and 2002 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.
Install gauge 9995452 at the rear of the camshafts.
Check that the screws securing the adjustment tool to the camshafts and the screw holding the tool together are well tightened
Remove (timing gear pulley with variable valve timing unit)
- the plug at the front of the variable valve timing unit (Tx55)
- the center screw in the variable valve timing unit (Tx55). Carefully pull out the variable valve timing unit with the timing gear pulley.
Remove (timing gear pulley without variable valve timing unit)
- the screws securing the timing gear pulley on the camshaft
- the timing gear pulley.
Remove tool 999 5452.
Reinstall the expansion tank and the brake fluid reservoir at the wing liner.