Preparation (common)
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Volvo S80, 2005 Volvo S80, 2004 Volvo S80, 2003 Volvo S80, and 2002 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.
Remove
- ground strip from the engine stabilizer brace
- the screw from the upper mounting for the transmission dipstick pipe
- engine stabilizer brace
- ignition coils, without
disconnecting connectors.NOTE:
Mark up before removal.
- both ground terminals
- the connector for the variable valve timing solenoid
- the connector for the engine coolant temperature (ECT) sensor.
Put the wiring and ignition coils to one side.
- the right front wheel
- the plastic nuts on the cover on the fender liner.