Finishing Work (Common)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Volvo S80, 2005 Volvo S80, 2004 Volvo S80, 2003 Volvo S80, and 2002 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Ignition Coils & Connectors

Courtesy of VOLVO CARS OF NORTH AMERICA.

Install

plugs in inspection holes. Tighten to 20 Nm .
NOTE:
Take care when tightening the plugs for the inspection holes.

Do not exceed the torque listed or the threads in the cam cover may strip.
the ignition coils according to the earlier markings
both ground terminals
the connector for the variable valve timing solenoid
the connector for the engine coolant temperature (ECT) sensor
engine stabilizer brace. Tighten to 50 Nm
ground strip to the engine stabilizer brace
the screw for the upper mounting for the transmission dipstick pipe.

Remove tool 999 5755.