Finishing Work (B6294S)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Volvo S80, 2005 Volvo S80, 2004 Volvo S80, 2003 Volvo S80, and 2002 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Ignition Coils & Connectors

Courtesy of VOLVO CARS OF NORTH AMERICA.

Install

the trigger wheel. Tighten to 17 Nm .
NOTE:
Ensure that the trigger wheel is correctly positioned against the camshaft.
the camshaft position (CMP) sensor housing
the clamps that hold the wiring to the rear of the cylinder head
the cover over the ignition coils
the upper timing cover
the engine stabilizer brace. Tighten the screws at the suspension turret. Tighten to 50 Nm . Tighten the screw on the engine stabilizer brace. Tighten to 80 Nm
the covers over the suspension turrets
the plastic nuts for the cover in fender liner
the right front wheel Installing wheels .