Finishing Work (B6284T)
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Volvo S80, 2005 Volvo S80, 2004 Volvo S80, 2003 Volvo S80, and 2002 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.
Install
- new cover at the rear edge of the intake camshaft
- the clamps that hold the wiring to the rear of the cylinder head
- the cover over the ignition coils
- the upper timing cover
- plastic charge air / intake pipe over the engine. Tighten the clamps
- the engine stabilizer brace. Tighten the screws on the suspension turret. Tighten to 50 Nm . Tighten the screws on the engine stabilizer brace. Tighten to 80 Nm
- the covers over the suspension turrets
- plastic nuts on the cover in the fender liner
- the right front wheel Installing wheels .