LEMON Manuals: Even more car manuals for everyone
Home >> Volvo >> 2002 >> S60 Base, 2.4 61, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 48 (Engine - Cleaning, Inspection And Adjustment) >> Transmission (B6284T; 1999) >> Variable Valve Timing Unit, Checking And Adjusting >> Installing And Adjusting The Variable Valve Timing Unit/Gear Pulley On The Camshafts >> Installing The Tensioner/Damping Unit

Installing The Tensioner/Damping Unit

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Volvo S80, 2005 Volvo S80, 2004 Volvo S80, 2003 Volvo S80, and 2002 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Tensioner/Damping Unit
GLL108819Courtesy of VOLVO CARS OF NORTH AMERICA.

Check that there is no visible leakage.

Press the tensioner/damping unit together using: 9995456 .

Position the tensioner/damping unit in the tool and screw the tool center nut to the bottom. Wait until compression is complete and install a lock pin in the piston.

NOTE:

The tensioner damping unit must be replaced if there is leakage or there is no resistance when pushed in or if it cannot be pushed in.

Install the tensioner/damping unit. Tighten to 25 Nm  .

scientia non olet · About LEMON Manuals