Removing Components From The Turbocharger (TC)
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Volvo S80, 2005 Volvo S80, 2004 Volvo S80, 2003 Volvo S80, and 2002 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.
Mark up the vacuum hose for the pressure regulator on the turbocharger (TC).
Remove:
- the vacuum hose from the pressure regulator on the turbocharger (TC)
- the cable for the heated oxygen sensors (HO2S) from the clips and clamps
- the upper heat deflector plate from the turbocharger (TC)
- the pipe screw for the oil pressure pipe in the turbocharger (TC). Discard the gaskets
- the pipe screws for the upper coolant pipe from the turbocharger (TC). Discard the gaskets.
Remove:
- the clamp between the turbocharger (TC) oil pressure line and the oil return line
- the screws where the oil return line connects to the turbocharger (TC). Pull the pipe from the cylinder block.
NOTE:
Check that the rubber sealing ring comes away with the pipe. Seal the opening in the cylinder block.
Remove:
- the pipe screws for the lower coolant pipe from the turbocharger (TC). Discard the gaskets
- the pipe screw for the oil pressure pipe in the engine block. Discard the gaskets.
NOTE:
Collect any oil spilled under the pipe screws in the cylinder block.
Remove the oil pressure pipe.