Installing The Throttle Body (TB)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Volvo S80, 2005 Volvo S80, 2004 Volvo S80, 2003 Volvo S80, and 2002 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.

Install:

the throttle body (TB). Use a new gasket . Tighten. Connect the throttle body (TB) connector
the pipe between the throttle body (TB) and the charge air cooler (CAC)
the intake manifold between the front cover plate and the air cleaner (ACL) housing
the battery negative lead. Battery, disconnecting .

NOTE:

After replacing the throttle unit, the throttle unit must be adapted using the vehicle communication input: "Adaptation of the electronic throttle unit". (Requires Volvo scan tool.)

Remedy as necessary.