Installing The Catalytic Converter Unit With The Heat Deflector Plate
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Volvo S80, 2005 Volvo S80, 2004 Volvo S80, 2003 Volvo S80, and 2002 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.
Use new nuts and gaskets .
NOTE:
Lubricate all the studs. Use paste, P/N: 116 1408 . Avoid skin contact with the paste.
Connect to the manifold. Install all the nuts. Use a mobile jack with universal plate 9995972 as support.
NOTE:
Ensure that the heated oxygen sensor (HO2S) wiring is correctly routed over the brake pipe.
Press the brake pipe into place in its holder on the front SIPS member.
Connect to the rear exhaust pipe. Install all nuts loosely.
Install the screws for the front SIPS member.
Remove the mobile jack.
Tighten
- the nuts for the front flange seal
- the front SIPS member
- the rear flange seal nuts.
Install the rear SIPS member. Tighten.