Transferring Components When Replacing Catalytic Converters

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Volvo S80, 2005 Volvo S80, 2004 Volvo S80, 2003 Volvo S80, and 2002 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Three-Way Catalytic Converter With The Heat Deflector Plate Removed

Courtesy of VOLVO CARS OF NORTH AMERICA.

Remove the holders for the rear heated oxygen sensors (HO2S) wiring holders.

Lift out the heat deflector plate.

Remove the heated oxygen sensors (HO2S).

Remove the three-way catalytic converter (TWC) mountings and the SIPS member.

Install

the mountings and SIPS member on the new three-way catalytic converter (TWC)
the heated oxygen sensors (HO2S). Tighten to 45 Nm .
NOTE:
Lubricate the thread using paste, P/N: 116 1408 .

Position the heat deflector plate.

Press the rear heated oxygen sensors (HO2S) holders into place.

NOTE:

Handle the new three-way catalytic converter (TWC) boot carefully. It is sensitive to twisting.