Installing The Rear Probe

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Volvo S80, 2005 Volvo S80, 2004 Volvo S80, 2003 Volvo S80, and 2002 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

For tightening torques, see Tightening torque .

Install:

the rear heated oxygen sensor (HO2S). Tighten to 45 Nm . Use tool 9995543
the wiring for the heated oxygen sensor (HO2S) in clips and clamps. Connect the wiring
a new gasket and new nuts at the join between the three-way catalytic converter (TWC) and the exhaust system. Tighten to 24 Nm
the rubber mounting for the three-way catalytic converter (TWC)
the front SIPS member. Press the brake pipe into place in the member
the lower engine cover.

Erase Diagnostic Trouble Codes (DTCs).

Reset trim.