Wastegate Valve, Adjusting: Reinstall
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Volvo S80, 2005 Volvo S80, 2004 Volvo S80, 2003 Volvo S80, and 2002 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.
Install the split pin on the lever.
Tighten the lock-nut on the push rod.
Remove the test equipment.
Connect the hose.
Install the heat shield.
Erase any diagnostic trouble codes (DTCs).
Test drive the car. Accelerate to wide open throttle (WOT) a couple of times.
Then check that no diagnostic trouble codes (DTCs) have been stored.