Crankcase Ventilation And Electronic Throttle Module (ETM), Cleaning: Removing

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Volvo S80, 2005 Volvo S80, 2004 Volvo S80, 2003 Volvo S80, and 2002 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Hoses And T-Nipple

Courtesy of VOLVO CARS OF NORTH AMERICA.

Remove:

the battery lead from the battery negative terminal, see:
Electrical system

Battery, replacing
the dipstick tube
the thick hoses, from the T-nipple.

Fig 2: Identifying Dipstick Tube

Courtesy of VOLVO CARS OF NORTH AMERICA.

Remove the intake manifold between throttle body and the air cleaner (ACL).

Fig 3: Identifying Gasket And Upper Section Of Intake Pipe

Courtesy of VOLVO CARS OF NORTH AMERICA.

Remove the 10 x screws at the mating flange of the intake manifold.

Lift off the upper section of the intake manifold.

Install 9995723

Fig 4: Identifying Throttle Body And Screws

Courtesy of VOLVO CARS OF NORTH AMERICA.

Remove the 4 x screws for the throttle body.