Crankcase Ventilation And Electronic Throttle Module (ETM), Cleaning: Installing: Install

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Volvo S80, 2005 Volvo S80, 2004 Volvo S80, 2003 Volvo S80, and 2002 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Throttle Body And Screws

GLL153610

Courtesy of VOLVO CARS OF NORTH AMERICA.

Install:

the throttle body. Use a new gasket
the 4 x screws for the throttle body.

Fig 2: Identifying Gasket And Upper Section Of Intake Pipe

GLL125914

Courtesy of VOLVO CARS OF NORTH AMERICA.

Remove 9995723

Install:

a new gasket
upper intake manifold section. Tighten the screws from the outside alternately.

Fig 3: Identifying Dipstick Tube

GLL102985

Courtesy of VOLVO CARS OF NORTH AMERICA.

Install the intake manifold between the throttle body and the air cleaner (ACL).

Fig 4: Identifying Hoses And T-Nipple

GLL153030

Courtesy of VOLVO CARS OF NORTH AMERICA.

Install:

the thick hoses to the T-nipple
NOTE:
The T-nipple's thickest connector to the flame trap.
the dipstick tube

Connect the negative battery lead. Battery, disconnecting