Removing camshaft position (CMP) sensor

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Volvo S80, 2005 Volvo S80, 2004 Volvo S80, 2003 Volvo S80, and 2002 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.

Remove the preheating pipe from the air cleaner (ACL): Applies only to B6xx4S engines .

Fig 1: Identifying Intake Manifold Between Front Cover Plate And Air Cleaner Housing

Courtesy of VOLVO CARS OF NORTH AMERICA.

Applies only to B6xx4T

Remove the intake pipe between the front cover plate and the air cleaner (ACL).

Fig 2: Identifying Mass Air Flow Sensor And Turbocharger (TC) Control Valve Connector

Courtesy of VOLVO CARS OF NORTH AMERICA.

Remove the clamp on the hose between the mass air flow (MAF) sensor and the pipe to the turbocharger (TC)
Remove the turbocharger (TC) control valve from the air cleaner (ACL) housing
Disconnect the turbocharger (TC) control valve connector
Remove the air cleaner (ACL) housing. Place it to one side
Remove the hose clamp from the crankcase ventilation and the heater hose.

Fig 3: Identifying Camshaft Position Sensor Connector

Courtesy of VOLVO CARS OF NORTH AMERICA.

Hose bracket.

Disconnect the connector at the bracket

Remove the cable from the clamp on the cylinder block.

Remove the camshaft position (CMP) sensor housing. Applies only to B6xx4T engines .

Remove the sensor mounting screw. Pull off sensor.