Removing the knock sensor (KS)
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Volvo S80, 2005 Volvo S80, 2004 Volvo S80, 2003 Volvo S80, and 2002 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.
Remove
- the cable from the battery negative terminal. First read Battery, disconnecting
- the intake pipe between the front cover plate and the air cleaner (ACL)
Detach the pipe from the charge air cooler at the throttle housing. Push the pipe to one side
- the dip stick and its holder
- the screws for the knock sensors (KS)
- the tie strap at the connector.
Disconnect the connector. Pull the sensors downwards and past the rear edge of the starter motor bracket.