Inflatable curtain module: Installation

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Volvo S80, 2005 Volvo S80, 2004 Volvo S80, 2003 Volvo S80, and 2002 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Deflector Clips (A & B)

Courtesy of VOLVO CARS OF NORTH AMERICA.

NOTE:

If the inflatable curtain module is dropped, it must not be installed.

Install:

the deflector with clips A and B.

NOTE:

The deflector on the C/D post must be installed before the inflatable curtain module is installed

Fig 2: Identifying Screws And Clips (C & E)

Courtesy of VOLVO CARS OF NORTH AMERICA.

Install:

lift in and knock the packaging according to the instructions
clips C and D
screw 1 (screw in until the thread engages only).

Remove the packaging by pulling it straight downwards.

NOTE:

Ensure that no bits of paper remain.

Install:

screws 2 and 8
clip E.

(4 and 5 are installed when installing the grab handles)

Fig 3: Identifying Screws And Clips (G & D)

Courtesy of VOLVO CARS OF NORTH AMERICA.

Hook on the inflatable curtain module. Install screw 3.

NOTE:

It is very important that the hook is correctly installed.

Install:

clip G.

(6 and 7 are installed when installing the grab handles)

Tighten screws 1-7. Tighten to 10 Nm.

Install:

The connector
The headlining. See Headlining, replacing

CAUTION:

When replacing the inflatable curtain module, part of the decal on the curtain must be torn off and stuck on the decal in the door opening.