Removing seat airbag modules (SIPS)

Remove the seat from the vehicle. See Lifting the front seats in and out .

Release the tension in the lumbar support.

Remove the lumbar support adjustment knob. First unscrew the knob counter-clockwise as far as it will go. Continue screwing counter-clockwise and pull out hard.

Remove: 

• the side piece by pulling it straight out
• the backrest adjustment knob. Pull the knob straight out. This applies only to manual seats
• the 5 half moon clips from the bottom of the backrest.

Remove the upholstery up to the first lateral channel. There are 2 half moon clips on each front-rear channel.

Remove 3 half moon clips from the first lateral channel.

Fig 1: Identifying Five Half Moon Clips At Bottom Edge Of Backrest

Courtesy of VOLVO CARS OF NORTH AMERICA.

Remove another half moon clip from each side of the front-rear channels up to the upper front-rear channel.

Fig 2: Identifying Spring

Courtesy of VOLVO CARS OF NORTH AMERICA.

Remove the 2 elastic attachments on the inside/reverse of the backrest.

Pull up the backrest upholstery.

Bend out and expose the protective pad on the side where the airbag is located.

Fig 3: Identifying Removal Of Airbag Screws On Inside Of Backrest Frame

Courtesy of VOLVO CARS OF NORTH AMERICA.

Remove the 2 screws holding the airbag to the inside of the backrest frame.

Pull the airbag downwards. Fold the airbag slightly forward.

Remove the airbag.

Fig 4: Identifying Cable Tie

Courtesy of VOLVO CARS OF NORTH AMERICA.

Cut the tie strap.

Fig 5: Identifying Half Moon Clips At Rear Edge Of Cushion Underside

Courtesy of VOLVO CARS OF NORTH AMERICA.

Cut off the 2 tie straps.

Release the cable harness.

Replace the airbag.