LEMON Manuals: Even more car manuals for everyone
Home >> Volvo >> 2002 >> S60 Base, 2.4 61, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 35 (Supplemental Restraint System Module (SRS) - General Diagnostics And Tests) >> Connecting The Breakout Box, Supplemental Restraint System Module (SRS) (2005-2006) >> Connecting the breakout box >> General Information

General Information

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Volvo S80, 2005 Volvo S80, 2004 Volvo S80, 2003 Volvo S80, and 2002 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Avoid touching control module connector pins and corresponding cable harness connectors. There is a risk of electrostatic discharge, which could damage the control module. Relieve any charge on yourself and the tools to be used by holding the metal part of the tool and touching part of the body just before starting work.

Visually check the connectors to ensure that the male and female terminals are not damaged and that the cables for the female halves are properly connected.

The breakout box is designed to facilitate reading off the control module input and output signals and the cable and component resistance when the control module is disconnected. The use of a breakout box reduces the risk of accidental short-circuited cables and damage to the connector pins.

scientia non olet · About LEMON Manuals